Silver and Fluoride Salivary Levels After the Application of Silver Fluoride

Overview

The aim of the study is to measure salivary fluoride and silver levels up to 7 days post-treatment. The participants will be 6 healthy adults. They will be given a fluoride free toothpaste to use the day before the study and all during the study. 3 participants will have 6 teeth treated (Group A).3 participants will have 28 teeth treated each on the facial aspect (Group B). On day 0, the participant will be given 25 ml of de-ionized fluoride free water to swish in the mouth and spit the entire contents into a 50 ml collection tube. This will be done 3 times. On day 0, 10 minutes after the rinsing and spitting, the participant will provide a unstimulated salivary sample into a universal collection tube until 5 ml are collected. The tubes with saliva will be stored on ice and then frozen at -20oC for transfer to the lab at the University of Washington. On Day 0, Isolation and application of silver fluoride. The quadrant will be isolated with cotton rolls, and surrounding gingiva will be covered with petroleum jelly to provide additional protection. After application, participant will be given 25 ml of fluoride free water to rinse as in 1 above and water collected. This will be done 10 times. DAY 1-6 Salivary Collection Measures: Fluoride will be measured using standard fluoride electrode analysis (Martinez-Mier et al., 2011). Silver will be measured using Inductively Coupled Plasma-Mass Spectrometry (EPA 6020a Rev.1 2007) at the University of Washington

Aim: to measure salivary fluoride and silver levels up to 7 days post-treatment. Based on extrapolation of the study by Vasquez and colleagues (2012), it is hypothesized that 7-day levels in the clinical study will not exceed baseline values. Participants: 6 healthy adults of either sex, 21+ years old, who do not have gingivitis but who have generalized gingival recession \>1mm, 3 subjects must have at least 28 teeth. Participants will be given a fluoride free toothpaste to use the day before the study and all during the study. Participants will be reminded not to use fluoride toothpaste or other fluoride products and to avoid fish and tea. No toothbrushing or eating at all within an hour of any visit Design: Observational study with each participant as his/her own control. 3 participants will 6 treated (Group A).3 participants will have 28 teeth treated each on the facial aspect (Group B). Teeth with anterior fillings or decay at the gingival where staining would show will not be treated. Day 0 Procedures: 1. On day 0, the participant will be given 25 ml of de-ionized fluoride free water to swish in the mouth and spit the entire contents into a 50 ml collection tube. This will be done 3 times. 2. On day 0, 10 minutes after the rinsing and spitting, the participant will provide a unstimulated salivary sample. The individual will be instructed to swallow once, and allow saliva to pool in the mouth without swallowing, and then periodically spit the saliva into a universal collection tube until 5 ml are collected. The tubes with saliva will be stored on ice and then frozen at -20oC for transfer to the lab at the University of Washington. 3. Day 0, Isolation and application of silver fluoride. GROUP A (6 TEETH): 18 mcL will be expressed from a Hamilton syringe into a dappen dish, and then a single preweighed microbrush will be used to apply the material to the tooth surface after drying with cotton gauze. The 6 teeth will be treated consecutively until all the material in the dappen dish will be used. Then the brush will be reweighed to establish the non-applied amount. GROUP B (28 TEETH) Measure out 3 mcL X number of teeth present into dappen dish. Procedure is the same. Application of silver fluoride. The quadrant will be isolated with cotton rolls, and surrounding gingiva will be covered with petroleum jelly to provide additional protection. 4. Day 0, after application, participant will be given 25 ml of fluoride free water to rinse as in 1 above and water collected. This will be done 10 times. DAY 1-6 Salivary Collection 5. Days 1-6, collection a single salivary sample at same time each day. Procedure: Ten minutes before collection (on days 1-6), each individual will be given 100 ml of de-ionized fluoride free water to rinse the mouth and swallow to increase hydration. The individual will be instructed to swallow once, and allow saliva to pool in the mouth without swallowing, and then periodically spit the saliva into a universal collection tube until 5 ml are collected. The tubes with saliva will be stored on ice and then frozen at -20oC for transfer to the lab at the University of Washington. Measures: Fluoride will be measured using standard fluoride electrode analysis (Martinez-Mier et al., 2011). Silver will be measured using Inductively Coupled Plasma-Mass Spectrometry (EPA 6020a Rev.1 2007).