This method development study will be a two treatment arm, randomized, cross over study in a population with edentulous upper arch restored with a maxillary complete denture. The lower may be a partial or full edentulous mandibular arch that may be restored with a stable complete, partial or implant supported denture.
This is a single-center, 2 treatment periods, examiner-blind, randomized, 7 day crossover study in adult participants with a complete maxillary denture. This is a method development study to investigate the changes in the level of denture plaque, microbial counts, microbial composition and stain on the maxillary dentures after daily denture cleanser use versus dentures that are cleaned weekly.
Study Type
INTERVENTIONAL
Allocation
RANDOMIZED
Purpose
BASIC_SCIENCE
Masking
SINGLE
Enrollment
19
One denture cleansing tablet will be soaked in a cup of very warm water (150 ml) with dentures for Day 0 to Day 7 for 15 mins. Brush dentures for 30 seconds using the solution, rinse under running water for 10 seconds.
One denture cleansing tablet will be soaked in cup of very warm water (150 ml) from Day 0 to Day 6 for 15 mins; and in cup of very warm water (150 ml) with 1 denture cleansing tablet on Day 7 at site for 15 mins. Brush dentures for 30 seconds using the solution, rinse under running water for 10 seconds.
A cup of very warm water will be used to soak one denture cleansing tablet and dentures for per day (Day 0 to Day 7) or weekly (Day 0 and Day 7) treatment regimen.
GSK Investigational Site
Glasgow, United Kingdom
Change From Baseline in Aerobic Bacteria Microbial Count on Day 7
Microbial count samples were collected using a paper disc (disc sampling). A pre-sterilised 10-millimeter (mm) filter paper disc was lightly pressed against the selected quadrant of maxillary denture, leaving enough space to place two discs without overlap. The selected areas were lateral to the midline and corresponding to the palatal rugae. Microbiological sampling was carried out from one standardised site on the fitting surface of the denture for standard culture. The discs were left for 20 secs prior to aseptic removal using sterile tweezers, and were serially diluted and plated into appropriate agar plates and incubated aerobically. Pre-treatment samples were taken from the left rough and left smooth denture surface. Post-treatment samples were taken from the right rough and right smooth denture surface at Day 7.
Time frame: Baseline (Day 0 pre-treatment), Day 7 (post-treatment)
Change From Baseline in Anaerobic Bacteria Microbial Count on Day 7
Microbial count samples were collected using a paper disc (disc sampling). A pre-sterilised 10 mm filter paper disc was lightly pressed against the selected quadrant of maxillary denture, leaving enough space to place two discs without overlap. The selected areas were lateral to the midline and corresponding to the palatal rugae. Microbiological sampling was carried out from one standardised site on the fitting surface of the denture for standard culture. The discs were left for 20 secs prior to aseptic removal using sterile tweezers, and were serially diluted and plated into appropriate agar plates and incubated anaerobically. Pre-treatment samples were taken from the left rough and left smooth denture surface. Post-treatment samples were taken from the right rough and right smooth denture surface at Day 7.
Time frame: Baseline (Day 0 pre-treatment), Day 7 (post-treatment)
Change From Baseline in Candidal Microbial Count on Day 7
Microbial count samples were collected using a paper disc (disc sampling). A pre-sterilised 10 mm filter paper disc was lightly pressed against the selected quadrant of maxillary denture, leaving enough space to place two discs without overlap. The selected areas were lateral to the midline and corresponding to the palatal rugae. Microbiological sampling was carried out from one standardised site on the fitting surface of the denture for standard culture. The discs were left for 20 secs prior to aseptic removal using sterile tweezers, and were serially diluted and plated into appropriate agar plates and incubated aerobically. Pre-treatment samples were taken from the left rough and left smooth denture surface. Post-treatment samples were taken from the right rough and right smooth denture surface at Day 7.
This platform is for informational purposes only and does not constitute medical advice. Always consult a qualified healthcare professional.
Time frame: Baseline (Day 0 pre-treatment), Day 7 (post-treatment)
Change From Baseline in Aerobic Bacteria Microbial Count on Day 3
Microbial count samples were collected using a paper disc (disc sampling). A pre-sterilised 10 mm filter paper disc was lightly pressed against the selected quadrant of maxillary denture, leaving enough space to place two discs without overlap. The selected areas were lateral to the midline and corresponding to the palatal rugae. Microbiological sampling was carried out from one standardised site on the fitting surface of the denture for standard culture. The discs were left for 20 secs prior to aseptic removal using sterile tweezers, and were serially diluted and plated into appropriate agar plates and incubated aerobically. Pre-treatment samples were taken from the left rough and left smooth denture surface. Post-treatment samples were taken from the right rough and right smooth denture surface at Day 3.
Time frame: Baseline (Day 0 pre-treatment), Day 3 (post-treatment)
Change From Baseline in Anaerobic Bacteria Microbial Count on Day 3
Microbial count samples were collected using a paper disc (disc sampling). A pre-sterilised 10 mm filter paper disc was lightly pressed against the selected quadrant of maxillary denture, leaving enough space to place two discs without overlap. The selected areas were lateral to the midline and corresponding to the palatal rugae. Microbiological sampling was carried out from one standardised site on the fitting surface of the denture for standard culture. The discs were left for 20 secs prior to aseptic removal using sterile tweezers, and were serially diluted and plated into appropriate agar plates and incubated anaerobically. Pre-treatment samples were taken from the left rough and left smooth denture surface. Post-treatment samples were taken from the right rough and right smooth denture surface at Day 3.
Time frame: Baseline (Day 0 pre-treatment), Day 3 (post-treatment)
Change From Baseline in Candidal Microbial Count on Day 3
Microbial count samples were collected using a paper disc (disc sampling). A pre-sterilised 10 mm filter paper disc was lightly pressed against the selected quadrant of maxillary denture, leaving enough space to place two discs without overlap. The selected areas were lateral to the midline and corresponding to the palatal rugae. Microbiological sampling was carried out from one standardised site on the fitting surface of the denture for standard culture. The discs were left for 20 secs prior to aseptic removal using sterile tweezers, and were serially diluted and plated into appropriate agar plates and incubated aerobically. Pre-treatment samples were taken from the left rough and left smooth denture surface. Post-treatment samples were taken from the right rough and right smooth denture surface at Day 3.
Time frame: Baseline (Day 0 pre-treatment), Day 3 (post-treatment)