Purpose The purpose of this study is to determine whether application of Transcutaneous Electrical Nerve Stimulation (TENS) is effective on habituation to electrical current whether delivered at a fixed frequency of 100 Hz or at patterned frequency. The secondary purposes are to determine the effectiveness on mechanical pressure pain and the subjective perception of the subjects regarding habituation and comfort of the different stimulations.
Low frequency and low intensity TENS showed strong evidence of inefficiency while conventional high frequency TENS (around 100Hz) applied at "strong but comfortable" intensity proved strong evidence of efficacy on pressure pain. In addition, some studies have shown the importance of current intensity in the effect of TENS. Either in clinical practice and in research, TENS intensity is usually adjusted according to the sensation of the subjects "strong but comfortable" "strong just below the motor threshold", ...). Usually throughout the TENS applications there is a phenomenon called "habituation" that involve a wide decrease of the sensation of the current applied, even though the perception the output-parameters are maintained. In this sense, It has been seem that adjusting the intensity throughout the TENS intervention produced a greater hypoalgesic effect than when the intensity remained fixed. On the other hand, most TENS devices offer the possibility of modulating current with the aim of preventing habituation phenomenon. The modulation of the electric current consists of changing the characteristics of the current (pulse width, pulse frequency, ...) every few seconds during the intervention. Nevertheless, the most common pattern used is the frequency modulation. However, there is a lack of evidence regarding what it is the better methods to avoid habituation during a TENS application.
Study Type
INTERVENTIONAL
Allocation
RANDOMIZED
Purpose
TREATMENT
Masking
DOUBLE
Enrollment
39
Transcutaneous application of Conventional TENS current over the course of the superficial radial nerve in the right forearm for a 20 minutes session. The intensity of the current will increase until participants report a "strong but comfortable" sensation, just Transcutaneous application of Conventional TENS current over the course of the superficial radial nerve in the right forearm for a 20 minutes session. The intensity of the current will increase until participants report a "strong but comfortable" sensation, just below motor threshold. Currents parameters are: Frequency modulation: randomized pattern (from 80 to 120 Hz) Pulse width 200 microseconds
Transcutaneous application of Conventional TENS current over the course of the superficial radial nerve in the right forearm for a 20 minutes session. The intensity of the current will increase until participants report a "strong but comfortable" sensation, just below motor threshold. Currents parameters are: Frequency modulation: Scan of frequency from 80 to 120 Hz in 6/6 mode (frequency sweep from 80 Hz to 120 Hz in 6 seconds and from 120 to 80 Hz in 6 secons) Pulse width 200 microseconds
Juan Avendaño-Coy
Toledo, Spain
Habituation to electrical stimulation
Due to habituation it is necessary to increase the intensity of the current throughout the session. Two measures were recorded within this variable: i) the increase in current density (mA / cm2) throughout the session (difference between its initial frequency and final frequency value of the current) and the number of times the participant requested to increase the intensity (subjects were instructed to maintain the same threshold)
Time frame: Baseline
Habituation to electrical stimulation
Due to habituation it is necessary to increase the intensity of the current throughout the session. Two measures were recorded within this variable: i) the increase in current density (mA / cm2) throughout the session (difference between its initial frequency and final frequency value of the current) and the number of times the participant requested to increase the intensity (subjects were instructed to maintain the same threshold)
Time frame: during treatment at 15 min
Habituation to electrical stimulation
Due to habituation it is necessary to increase the intensity of the current throughout the session. Two measures were recorded within this variable: i) the increase in current density (mA / cm2) throughout the session (difference between its initial frequency and final frequency value of the current) and the number of times the participant requested to increase the intensity (subjects were instructed to maintain the same threshold)
Time frame: at 10 min. post-treatment
Mechanical pain threshold
The pressure pain threshold will be measured by a pressure digital algometer (Wagner Instruments, FDIX. Post Office Box 1217, Greenwich, CT 06836-1217 USA.) and will be expressed in Newton; on the back of the right hand (about 3 cm from the first interdigital foldand) . The mechanical pain threshold will be assessed 3 time in order to calculate the mean value.
Time frame: Baseline
This platform is for informational purposes only and does not constitute medical advice. Always consult a qualified healthcare professional.
Transcutaneous application of Conventional TENS current over the course of the superficial radial nerve in the right forearm for a 20 minutes session. The intensity of the current will increase until participants report a "strong but comfortable" sensation, just below motor threshold. Currents parameters are: Fixed frequency at 100 Hz Pulse width 200 microseconds
Electrodes are placed over the course of the superficial radial nerve in the right forearm for a 20 minutes in the same manner as experimental groups, but will be applied a sham electrical stimulation increasing the current intensity of an unconnected channel.
Mechanical pain threshold
The pressure pain threshold will be measured by a pressure digital algometer (Wagner Instruments, FDIX. Post Office Box 1217, Greenwich, CT 06836-1217 USA.) and will be expressed in Newton; on the back of the right hand (about 3 cm from the first interdigital foldand) . The mechanical pain threshold will be assessed 3 time in order to calculate the mean value.
Time frame: during treatment at 15 min.
Mechanical pain threshold
The pressure pain threshold will be measured by a pressure digital algometer (Wagner Instruments, FDIX. Post Office Box 1217, Greenwich, CT 06836-1217 USA.) and will be expressed in Newton; on the back of the right hand (about 3 cm from the first interdigital foldand) . The mechanical pain threshold will be assessed 3 time in order to calculate the mean value.
Time frame: at 10 min. post-treatment
Perception current comfortability
Visual scale from 0 mm to 100 mm
Time frame: at 1min. post-treatment
Perception current habituation
Visual scale from 0 mm to 100 mm
Time frame: at 1min. post-treatment