Pathophysiological changes influenced by multiple factors in critically ill patients, has a significant impact on pharmacokinetics (PK) and pharmacodynamics (PD) of cisatracurium. In order to understand better and find an appropriate dosing regimen, the purpose of this study is to investigate the PK and PD of a loading dose cisatracurium in critically ill patients. Cisatracurium, nondepolarizing neuromuscular blocking agents (NMBAs), are commonly used in intensive care units because of a lesser effect on hemodynamic parameters and a reduction in mortality rate in ARDS patients. Loading dose recommended in clinical practice guidelines for sustained neuromuscular blockade in the adult critically ill patient is 0.1-0.2 mg/kg. Then, maintenance dose of 1-3 mcg/kg/min is followed regarding indications, such as ARDS. However, this recommended loading dose might not be adequate in critically ill patients, the study in this specific population might be needed.
Neuromuscular blocking agents (NMBAs) are commonly used in critically ill patients, especially in adult respiratory distress syndrome (ARDS). Use of NMBAs to facilitate mechanical ventilation, to control patient/ventilator asynchrony and to reduce uncontrolled muscle tone in special conditions including tetanus, therapeutic hypothermia, and status epilepticus were increasingly found in current clinical practice. Cisatracurium, 1Rcis-1'Rcis isomer of atracurium, is benzylisoquinolium nondepolarizing NMBAs which is three to five folds higher potency than atracurium besylate. The degradation of cisatracurium by hofmann elimination and ester hydrolysis in plasma generates laudanosine and a monoquaternary acrylate metabolite. Clinical practice guidelines for sustained neuromuscular blockade in the adult critically ill patient published in year 2016 strongly recommended cisatracurium due to a reduction in incidence of prolonged blockade, cardiovascular related adverse events and anaphylactic reactions. Moreover, recent evidence showed that early use of cisatracurium in early severe ARDS patients led to a significant reduction in mortality. Regarding pharmacokinetics and pharmacodynamics of cisatracurium in critically ill patients, there were multiple factors affected cisatracurium blood concentration and neuromuscular blockade actions. Several reports demonstrated that pathophysiological changes, such as age, hypothermia/ hyperthermia, electrolyte imbalance and acid-base disturbances, had a significant impact on PK and PD of cisatracurium. Currently, there were an increasing data of slow response and less paralysis effect in critically ill patients receiving standard dose of cisatracurium. These may be explained by inadequate drug concentration at target organ, therefore, treatment failures regarding recommended dose of cisatracurium has been reported. Consequently, higher cisatracurium dose with higher drug concentration level might overcome a problem of inadequate level and therapeutic failure while receiving a standard dose of cisatracurium (a loading dose of 0.1-0.2 mg/kg, followed by a maintenance dose of 1-3 mcg/kg/min)
Study Type
INTERVENTIONAL
Allocation
NA
Purpose
BASIC_SCIENCE
Masking
NONE
Enrollment
10
A single dose of 0.2 mg/kg intravenous bolus cisatracurium will be administered and blood samples will be taken before and at least 7 occasions post dose (at 1, 5, 10, 12, 15, 20, 30, and/or 60 minutes after a single bolus).
Faculty of Medicine Ramathibodi Hospital
Bangkok, Thailand
Total plasma concentration-time data
Data will be collected in case-record form and managed by Microsoft Office Excel. Statistical analyses will be performed using SPSS.
Time frame: Pre-dose through 60 minutes post-dose
Patient-ventilator asynchrony - time data
Data will be collected in case-record form and managed by Microsoft Office Excel. Statistical analyses will be performed using SPSS.
Time frame: Pre-dose through 60 minutes post-dose
The degree of neuromuscular block by train-of-four-watch monitor - time data
Data will be collected in case-record form and managed by Microsoft Office Excel. Statistical analyses will be performed using SPSS.
Time frame: Pre-dose through 60 minutes post-dose
Time to maximum concentration
Analysis of time to maximum concentration will be performed with a nonlinear mixed-effects population modelling approach as implemented in NONMEM software.
Time frame: Pre-dose through 60 minutes post-dose
Half-life
Analysis of half-life will be performed with a nonlinear mixed-effects population modelling approach as implemented in NONMEM software.
Time frame: Pre-dose through 60 minutes post-dose
Clearance
Analysis of clearance will be performed with a nonlinear mixed-effects population modelling approach as implemented in NONMEM software.
Time frame: Pre-dose through 60 minutes post-dose
Elimination rate constant
Analysis of elimination rate constant will be performed with a nonlinear mixed-effects population modelling approach as implemented in NONMEM software.
Time frame: Pre-dose through 60 minutes post-dose
Time to maximum block
Data will be collected in case-record form and managed by Microsoft Office Excel. Statistical analyses will be performed using SPSS.
Time frame: Pre-dose through 60 minutes post-dose
Percentage of maximum block
Data will be collected in case-record form and managed by Microsoft Office Excel. Statistical analyses will be performed using SPSS.
Time frame: Pre-dose through 60 minutes post-dose
Time to patient-ventilator synchrony
Data will be collected in case-record form and managed by Microsoft Office Excel. Statistical analyses will be performed using SPSS.
Time frame: Pre-dose through 60 minutes post-dose
This platform is for informational purposes only and does not constitute medical advice. Always consult a qualified healthcare professional.