The objective of this randomized controlled clinical trial is to evaluate the increase of soft tissue thickness around single implants installed in maxillary esthetic area with the use of Leucocyte-Platelet rich Fibrin (L-PRF) membranes. The sample is of 42 individuals, where the control group (n = 21) will receive single implant placement only, while the test group will receive single implant placement with L-PRF membranes.
The greatest challenge in implantology is to achieve a satisfactory esthetic result. A new platelet concentrate protocol, named Leucocyte and platelet-rich Fibrin (L-PRF), has been developed in France. Research has shown positive results using L-PRF during implant placement, as improving soft tissue healing and bone formation, leading to higher esthetic level and greater implant stability. The aim of this study is to evaluate if the use of PRF associated to implant placement in esthetic area presents superior aesthetic result and soft tissue thickness increase when compared to implant placement without graft. Forty-two patients requiring single implant placement in the esthetic area of the maxilla will be randomly divided into test group (implant + L-PRF) and control group (implant without graft). Surgical procedures will be performed by a single operator. The rates of soft tissue thickness, esthetic and comfort will be evaluated at baseline and 3 months after the procedure.
Study Type
INTERVENTIONAL
Allocation
RANDOMIZED
Purpose
TREATMENT
Masking
DOUBLE
Enrollment
42
The patient's blood will be collected and the tubes (4) will be inserted into a tabletop centrifuge (Kasvi). Using a 2500rpm for 12 minutes protocol, the leucocyte- and platelet-rich fibrin clot will be prepared using a kit consisting of a perforated metal box where the clots will be positioned and covered by a metal plaque. The pressure exerted on the clot will lead to the formation of L-PRF membranes, which will be used to cover the ridge after placement of the implant. Then, the flap will be sutured.
Single implant installation surgery in maxillary esthetic area.
Maria Jardini
São Jose Dos Campos, São Paulo, Brazil
Gain of peri-implant soft tissue thickness
A single investigator, who is not the operator, is responsible for the measurements of the patients. The examiner will be judged calibrated. The calibration will be made by examination of soft tissue thickness of 5 patients, twice, in a range of 48 hours. The correlation test will be used to verify the reproducibility of intra-examining measures, with a maximum value of 0.8. To ensure that the measures at baseline and postoperative evaluation will be performed at the same place, we will use a stent, made of condensation silicone (Optosil - Heraeus Kulzer), so as to cover the edentulous region and the regions of interest described by Zeltner et al. (2017). During measurements of soft tissue thickness, the stent will be used so that the tissue perforation site will be standardized, according to a marking on its surface. An endodontic spacer will be used for tissue perforation, and the thickness will be evaluated using a digital caliper.
Time frame: Three months
a) Plaque index (IP, Ainamo e Bay. 1975)
Assessment of presence or absence of plaque in a dichotomous pattern (0 - absence of visible plaque; 1 - presence of visible plaque);
Time frame: Three months
b) Gingival bleeding index (IG, Ainamo & Bay, 1975)
Assessment of presence or absence of bleeding in the gingival margin in a dichotomous pattern (0 - no bleeding; 1 - presence of bleeding)
Time frame: Three months
c) Buccal keratinized tissue thickness (ETQv)
Keratinized tissue thickness measured at the center of the region of interest (RDI) of the buccal surface of the ridge. To measure the tissue thickness, a guiding device will be made to standardize the region to be measured and then, at a specific point, the mucosa will be punctured with an endodontic spacer and the thickness marked with a rubber marker. Then, using a digital caliper, the thickness will be measured.
Time frame: Three months
This platform is for informational purposes only and does not constitute medical advice. Always consult a qualified healthcare professional.
d) Ridge defect (DR) (ridge valley)
Distance in millimeters from the buccal mucosa to the imaginary line passing through the vestibular bosses of the adjacent teeth, using a periodontal probe.
Time frame: Three months
e) Soft tissue height (ATM)
Distance from the top of the gingival tissue on the edge of the ridge to the top of the stent, measured using a endodontic spacer with rubber marker to measure height, and then measure with a digital caliper.
Time frame: Three months
f) Height of keratinized tissue (ATQ)
Vertical distance in millimeters measured on the center of the ridge on the buccal aspect of the edentulous ridge to the mucogingival line, using a periodontal probe.
Time frame: Three months
g) Distance between the teeth adjacent to the edentulous space (DED)
Measure of the distance between the proximal faces of the teeth adjacent to the edentulous area, using a periodontal probe.
Time frame: Three months
h) Vestibular bone plate thickness (ETV)
The thickness of the buccal bone plate, measured in millimeters, after the perforations of the ridge prior to implant installation. Measured using photos taken during the surgery.
Time frame: During the surgical procedure
i) Distance between implant and adjacent teeth (DEID)
Measurements between the implant to the adjacent teeth, mesial and distal. measured using photos taken during the surgery.
Time frame: During the surgical procedure
j) Distance from the implant to the imaginary line passing by the buccal aspect of the adjacent teeth (DILIV)
Measured from the vestibular aspect of the implant to the imaginary line passing through the buccal faces of the adjacent teeth. Measured using photos taken during the surgery.
Time frame: During the surgical procedure
k) Distance from the buccal bone plate to the imaginary line of the adjacent teeth (DTOVLI)
Measured from the buccal bone plate to the imaginary line of the buccal faces of the adjacent teeth, measured using photos taken during the surgery.
Time frame: During the surgical procedure
l) Distance from the interproximal bone crest to the cementum-enamel junction of neighboring teeth (DCOJCE)
Linear measurement from the top of the bone crest to the JCE of the mesial and distal neighboring teeth to the edentulous space (with a periodontal probe)
Time frame: During the surgical procedure
m) Evaluation of the periodontal biotype (thin or thick)
Classified on thin or thick periodontal biotype, according to Olsson and Lindhe, 1991 and Kan et al., 2010. Thin, if the marginal vestibular gingiva is more delicate, the papillae are high and thin and the crown of the central incisors are triangular shaped; Thick if the marginal gingiva is thicker, papillae are short and the central incisors are square shaped.
Time frame: Three months