The investigators designed this study to determine the test-retest reliability of the viscoelastic passive properties of the calf muscles assessed using isokinetic device in flexed and extended knee position. The second objective is to determine the clinical viability of the parameters using the coefficient of repeatability and to investigate the individual characteristics associated with increased calf stiffness or altered viscoelasticity
Recordings using an isokinetic dynamometer make it possible to quantify the resisting force during passive muscle stretch for a constant speed movement in dorsal flexion (flexion) and its release in plantar flexion (extension). The surface electromyography (EMG) makes it possible to measure voluntary contraction and the movement is considered passive if the corrected and normalized EMG signal, using root-mean-square (RMS), is less than 10% RMS during the Maximal Voluntary Muscle Contraction (MVMC). Stiffness is calculated from the slope of the rise of the curve during the passive dorsiflexion phase of the joint. The elastic potential energy can be measured and corresponds to the area under the curve during elongation. During the plantar flexion return phase, there is a hysteresis phenomenon resulting in behavior that differs from the curve. This difference between the two curves corresponds to the behavior related to viscoelastic relaxation. Viscoelasticity has a thixotropic behavior, i.e. it varies over time, for example, with heating. These parameters have been studied together or separately to evaluate the effect of age or stretching on the passive mechanical properties of the calf. However, the test-retest reliability of the viscoelastic passive properties of the calf muscles assessed using isokinetic device has not been demonstrated. The investigators designed this study to determine the test-retest reliability of the viscoelastic passive properties of the calf muscles assessed using isokinetic device in flexed and extended knee position. The second objective is to determine the clinical viability of the parameters using the coefficient of repeatability and to investigate the individual characteristics associated with increased calf stiffness or altered viscoelasticity Muscle tension is expressed by the peak torque (Nm), recorded at neutral position (PT0°) and 10° flexion (PT10°). Plantarflexor stiffness is determined as the slope of the torque-angle curve expressed as Nm·degree-1 during the linear region form 0-10° flexion (Slope0-10). A measure of elastic energy storage is calculated through the AUC of the torque-angle curve across the all range of motion. Hystérésis over time due to viscoelastic stress relaxation is calculated as the percent reduction in work absorption between the muscle stretching and releasing phases . The flexed-to-extended ratio is calculated as the ratio of flexed knee to extended knee and evaluated for PT0°, PT10° and Slope0-10 values , at 5 and 90°/sec
Protocol is the same for extended or flexed knee. The testing apparatus was set up as described in the constructor owner's manual and subjects were positioned in the supine lying position. The After a 5 min rest period, the participant's ankle is passively stretched through slow loading cycles from 15° of ankle flexion to 35° of ankle extension. Oral instruction is given to the participants to stay relaxed and avoid any muscle contraction and movement of the leg throughout the passive stretching. To familiarize, participant have 3 repetitions of passive ankle flexion-extension at 5°.s-1, and after 2min rest, data are collected from one repetitions at 5°.s-1 in passive mode. The measurements are also performed at an angular rate of 90°.s-1, according to the same protocol. Data for maximal voluntary isokinetic contraction are collected from 3 maximal repetitions at 60°.s-1 in concentric mode and participant are encouraged by constant verbal stimulation.
CHU Caen Normandie
Caen, France
Change from Baseline stiffness parameters at 15 days to assess the reproducibility of stiffness parameters
Change from Baseline stiffness parameters at 15 days, measurement of passive peak torque at 0 and 10° and slope of curve during the passive ankle flexion using an isokinetic device
Time frame: Two evaluations on both dominant and non dominant knees: one evaluation at the first visit, and a second evaluation at the second visit at 15 days after the first visit
Change from Baseline viscoelastic parameters at 15 days to assess the reproducibility of viscoelastic parameters
Change from Baseline viscoelasticity parameters at 15 days, measurement of hysterisis (AUC release/AUC storage) during the passive ankle flexion/extension using an isokinetic device
Time frame: Two evaluations on both dominant and non dominant knees: one evaluation at the first visit, and a second evaluation at the second visit at 15 days after the first visit
Patient characteristics
Personal characteristics recorded in the medical report as age, gender, type of sport and sport level of practice and previous lower limb injuries
Time frame: One evaluation only, at the first visit after inclusion
Physical characteristics, popliteal angle
The popliteal angle tested on both legs.
Time frame: One evaluation only, at the first visit after inclusion
Physical characteristics, Calf Circumference
The Calf Circumference (CC) tested on both legs.
Time frame: One evaluationsonly, at the first visit after inclusion (T1)
Physical characteristics, ROM
The passive ankle range of motion (ROM) tested on both legs.
This platform is for informational purposes only and does not constitute medical advice. Always consult a qualified healthcare professional.
Study Type
INTERVENTIONAL
Allocation
NA
Purpose
DIAGNOSTIC
Masking
NONE
Enrollment
16
Time frame: One evaluation only, at the first visit after inclusion
Physical characteristics, Fingertip-to-Floor (FTF) Test
The Fingertip-to-Floor (FTF) Test on both legs.
Time frame: One evaluation only, at the first visit after inclusion