Tension Band Wiring Versus Cannulated Screws in Fixation of Medial Malleolus in Ankle Fracture

medial malleolus fracture fixed with tension band wiring): 2 k.wires (1.6 mm) are inserted perpendicular to the fracture site. Again the position is checked under image intensification for the correct direction and length. We drilled a 2.5mm hole with a protection sleeve, 2-3cm above the level of the horizontal joint line, aiming the drill bit slightly inferiorly to avoid screw pullout. We inserted a 3.5mm unicortical screw about 30 mm in length (with or without washer), 2-3mm is left for the wire between the bone and screw head before full tightening. A steel wire is constructed into a figure of eight between the screw the reduction k. wires, then twisted to achieve interfragmentary compression

In group 2 (15 patients with medial malleolus fixed by 2 cannulated screws): Two guide wires (1.6mm) are inserted perpendicular to the fracture site, the appropriate length, proper insertion site including the distance from the articular surface is checked fluoroscopically .the length is measured .drilling of the bone through the threaded guide wire with a cannulated drill bit (3.2mm). A two 4.5mm partially threaded cannulated screws (with or two washers) are inserted through the guide to achieve Compression, the guide wires are then removed