The purpose of this First-in-Human study is to assess the safety, tolerability, pharmacokinetics, and pharmacodynamics of Ir-CPI, a novel dual inhibitor of FXIIa and FXIa, following IV administration of single ascending doses in healthy male volunteers.
Study Type
INTERVENTIONAL
Allocation
RANDOMIZED
Purpose
OTHER
Masking
DOUBLE
Enrollment
32
6 participants received a single intravenous dose of 1.5 mg/kg of Ir-CPI during 6 hours
6 participants received a single intravenous dose of 3.0 mg/kg of Ir-CPI during 6 hours
6 participants received a single intravenous dose of 6.0 mg/kg of Ir-CPI during 6 hours
A.T.C. Pharma
Liège, Belgium
Measurement of the Safety Lab Parameter Activated Partial Thromboplastin Time (aPTT)
These safety aPTT results were readily available to the PI for safety follow-up during and after the study drug administration. Safety aPTT was followed up "at the bedside" at regular time-points (as opposed to the PD biomarker aPTT, which was assessed by the central laboratory alongside the PK time-points). An aPTT ratio was calculated by dividing the aPTT value (in sec) of the specific time-point (aPTTt) by the baseline aPTT value (in sec) (aPTTbaseline) of the same participant (aPTT ratio = aPTTt/aPTTbaseline). The baseline time-point was considered as having an aPTT ratio of 1. Concerning the row titles, for example, Day 1 H02:00 corresponds to aPTT ratio results obtained on Day 1, 2 hours after the start of the infusion.
Time frame: At pre-dose (baseline), 2, 4, 6, 8, 12, 24, 48, 72 hours post-dose and at the discharge visit (Day 10 ± 2 days)
Measurement of the Maximum Plasma Concentration (Cmax) of Ir-CPI
Time frame: Pre-dose, 0.5, 1, 1.5, 2, 4, 6, 6.5, 7, 7.5, 8, 10, 12, 16, 24, 48, 72, 96, 144 hours (144 hours for Dose 4 only)
Measurement of the Time to Reach Maximum Plasma Concentration (Tmax) of Ir-CPI
Time frame: Pre-dose, 0.5, 1, 1.5, 2, 4, 6, 6.5, 7, 7.5, 8, 10, 12, 16, 24, 48, 72, 96, 144 hours (144 hours for Dose 4 only)
Measurement of the Area Under the Plasma Concentration-time Curve From Time Zero to 6h (AUC0-6) and From Time Zero to Time of Infinity (AUCinf)
Time frame: Pre-dose, 0.5, 1, 1.5, 2, 4, 6, 6.5, 7, 7.5, 8, 10, 12, 16, 24, 48, 72, 96, 144 hours (144 hours for Dose 4 only)
Measurement of the Effect of Ir-CPI on the Activated Partial Thromboplastin Time (aPTT)
The activated partial thromboplastin time (aPTT) is used as a pharmacodynamic marker. No data were available for the Ir-CPI 1.5 mg/kg group because the results were not usable due to plasma preparation and method repeatability problems. An aPTT ratio was calculated by dividing the aPTT value (in sec) of the specific time-point (aPTTt) by the baseline aPTT value (in sec) (aPTTbaseline) of the same participant (aPTT ratio = aPTTt/aPTTbaseline). The baseline time-point (Day 1 H00:00) was considered as having an aPTT ratio of 1. Concerning the row titles, for example, Day 1 H02:00 corresponds to aPTT ratio results obtained on Day 1, 2 hours after the start of the infusion.
This platform is for informational purposes only and does not constitute medical advice. Always consult a qualified healthcare professional.
6 participants received a single intravenous dose of 9.0 mg/kg of Ir-CPI during 6 hours
For each dose group, 2 additional participants received a single intravenous dose of placebo during 6 hours (8 in total).
Time frame: Pre-dose (baseline), 0.5, 1, 1.5, 2, 4, 6, 6.5, 7, 7.5, 8, 10, 12, 16, 24, 48, 72, 96 hours post-dose and at the discharge visit (Day 10 ± 2 days)
Measurement of the Effect of Ir-CPI on Factor XI Activity
The method is a clotting assay where all the clotting factors are present (constant and in excess, brought by the deficient plasma), excepted for FXI, which is brought by the diluted tested plasma, and clotting is triggered with cephalin, activator and calcium (aPTT). FXI is the limiting factor and clotting time is inversely proportional to the concentration of FXI. There is an inverse linear relationship between the percentage of FXI activity and the corresponding clotting time. Central laboratory normal ranges for Factor XI activity are between 65 and 150 %. Concerning the row titles, for example, Day 1 H02:00 corresponds to the percentage of FXI activity obtained on Day 1, 2 hours after the start of the infusion.
Time frame: Pre-dose (baseline), 0.5, 1, 1.5, 2, 4, 6, 6.5, 7, 7.5, 8, 10, 12, 16, 24, 48, 72, 96 hours post-dose and at the discharge visit (Day 10 ± 2 days)
Measurement of the Effect of Ir-CPI on Factor XII Activity
The method is a clotting assay where all the clotting factors are present (constant and in excess, brought by the deficient plasma), excepted for FXII, which is brought by the diluted tested plasma, and clotting is triggered with cephalin, activator and calcium (aPTT). FXII is the limiting factor and clotting time is inversely proportional to the concentration of FXII. There is an inverse linear relationship between the percentage of FXII activity and the corresponding clotting time. Central laboratory normal ranges for Factor XII activity are between 50 and 150 %. Concerning the row titles, for example, Day 1 H02:00 corresponds to the percentage of FXII activity obtained on Day 1, 2 hours after the start of the infusion.
Time frame: Pre-dose (baseline), 0.5, 1, 1.5, 2, 4, 6, 6.5, 7, 7.5, 8, 10, 12, 16, 24, 48, 72, 96 hours post-dose and at the discharge visit (Day 10 ± 2 days)