The purpose of the stud will be to compare the effect of pressure release with thoracic spine manipulation on pain intensity level and pain pressure threshold, thoracic spine ROM and physical function onactive rhomboids muscle trigger point in myofascial pain syndrome.
Myofascial pain syndrome (MPS) is one of the most common chronic disorders causing persistent musculoskeletal pain which is characterized by myofascial trigger points (MTrPs) in palpable taut bands of skeletal muscle. In recent years, due to our modern lifestyle people is exposed to postural stresses, inefficient biomechanics, repetitive postural dysfunction, which are some of the causes of myofascial pain syndrome .Active Rhomboid muscle trigger point are one of the main causes of inter- scapular pain, as the referral pattern of this muscle is on the medial border of the scapula. The aim of the study is to find if there any significant difference between the effect of pressure release and thoracic spine manipulation on pain intensity level, pain pressure threshold ,thoracic spine ROM and physical function and symptoms in people with musculoskeletal disorders of the upper limb on active rhomboids muscle trigger point in myofascial pain syndrome. 66 participants will be allocated randomly to three groups ; The Participants will be assigned randomly into three groups by simple methods of randomization. Control group: will receive conventional physical therapy treatment, Experimental group 1: will receive conventional physical therapy treatment in addition to pressure release Experimental group 2: will receive conventional physical therapy treatment in addition to thoracic spine manipulation.
Study Type
INTERVENTIONAL
Allocation
RANDOMIZED
Purpose
TREATMENT
Masking
DOUBLE
Enrollment
66
Participants in control group will receive conventional physical therapy treatment including Conventional TENS high frequency (90-130hz) low intensity according to the patient sensation for 30-45 min(Gozani, 2019) , continuous ultrasound with frequency 1 MHz and intensity 0.8 W/cm 2 will be applied by slow circular perpendicular movements with slightly deep pressure. Application time was 5 minutes at each side of the level of C7\_T4 along the medial borders of the scapulae width, infra-red radiation will be four 15 minutes and directed perpendicular to the inter-scapular area, centered at the level of C7\_T4 long and between the 2 medial borders of the scapulae width . Also combined stretching and strengthening exercise will be added due to its greater pain-relieving effect
Participants who are assigned to this group will receive conventionalphysical therapy treatment in addition to pressure release technique. the participant will be positioned either sitting or prone position according to his preferred position, the researcher will apply the pressure release procedure by a pressure below the PPT dependent onsoft tissue release. When the researcher detected a reduction in soft tissue resistance, the amount of compression will be increased. The pressure should -33- be nonpainful, applied at slow rate, and will maintained until release of tissue barrier. Further pressure was increased to reach a new barrier. The pressure will last 60 seconds. With the thumb or the second and third fingers, the non-painful manual therapy approach was applied to the active MTrPs of therhomboid muscle
Pain Intensity level
pain intensity level will be measured by visual analogue scale (VAS)
Time frame: up to three weeks
Pressure Pain threshold level (PPT)
pressure pain threshold level (PPT) will be measured by digital algometer
Time frame: up to three weeks
Rom of Motion
rom will be measured by digital inclinometer
Time frame: up to three weeks
Physical function
physical function will be measured by Disability of Arm, Shoulder, and Hand questionnaire (DASH)
Time frame: up to three weeks
This platform is for informational purposes only and does not constitute medical advice. Always consult a qualified healthcare professional.
Thoracic spine manipulation will be performed as screw thrust manipulation technique; the vertebral transverse processes will beforced from posterior to anterior direction. The direction of the manipulation should be identified by applying springing test to the adjacent spinous process to determine the painful and stiff segment. Patient will be prone and researcher hand placement will be positioned as the following one pisiform on the right facet of the above, and the other pisiform on the left facet of the below vertebrae.A slack will be taken up. The thrust applied directly toward the patient once