Twenty healthy volunteers were included in the study. The NIRS was placed on the thenar region of the hand. The vascular occlusion protocol had been done before and after cupping therapy (CT). Regional oxygen saturation (rSO2), the times to the lowest and highest values were recorded. The occlusion slope, the recovery slope and the first 10 second recovery slope were calculated.
Participants rested in a seated position at standard temperature for at least 10 minutes. A blood pressure cuff was applied to the upper arm, and the NIRS device (Covidien INVOS™ 5100C Cerebral/Somatic Oximeter, Dublin) was used to monitor regional oxygen levels in the thenar region of the hand throughout the protocol. After a 3-minute stabilization period, the vascular occlusion protocol commenced: the blood pressure cuff was inflated rapidly within 3-4 seconds to 50 mmHg above the baseline systolic blood pressure and maintained for 3 minutes, then deflated within 1 second. The participant rested for another 10 minutes before a certified cupping therapist placed a plastic therapy cup on the forearm, 5 cm from the medial and lateral epicondyles. The size of the cup was based on the participant's forearm, covering 50% of the area. The cup was vacuumed twice using a manual hand pump and left in place for 5 minutes before the air was released through the valve. Following a 3-minute stabilization period, the vascular occlusion protocol was repeated. During the test, rSO2 values and the time to reach the lowest and highest values were recorded. Using this data, the occlusion slope, recovery slope, and 10-second recovery slope were calculated. The occlusion slope was determined by the formula \[(baseline rSO2 - minimum rSO2) / time to lowest rSO2\], in %/minute. The recovery slope was calculated as \[(minimum rSO2 - maximum rSO2) / time to reach the highest rSO2\], in %/second. The 10-second recovery slope was calculated as \[(minimum rSO2 - rSO2 at 10 seconds) / 10 seconds\].
Study Type
INTERVENTIONAL
Allocation
NA
Purpose
SUPPORTIVE_CARE
Masking
NONE
Enrollment
20
After the initial vascular occlusion test and a subsequent 10-minute rest period, the plastic therapy cup was placed on the forearm, 5 cm away from the medial and lateral epicondyles by a certified cupping therapist. The size of used cup was determined according to the size of the volunteer's forearm which cover 50% of the area. The cup was vacuumed two times full pumping with a manual hand pump and remained in place for 5 minutes. And then the air was removed by releasing the cups through the release valve.
A blood pressure cuff was placed on the upper arm. The adult probe of the NIRS device (Covidien INVOS™ 5100C Cerebral/Somatic Oximeter, Dublin) was placed on the thenar region of the ipsilateral hand and the regional oxygen value was recorded during all study term. Baseline arterial pressure and oxygen saturation were monitored (GE Healthcare Oy, Helsinki, Finland) from the side of dominant hand and recorded. After a 3-minute stabilization period, the vascular occlusion protocol was started. The blood pressure cuff was rapidly inflated within 3-4 seconds to 50 mmHg above baseline systolic blood pressure and kept at this pressure during 3 minutes. Following this, the cuff was deflated within 1 second. Five minutes after cupping therapy this protocol had done again.
Tokat Gaziosmanpaşa üniversity
Tokat Province, Turkey (Türkiye)
the rSO2 values
monitored at tenar region on the dominant hand with near infrared spectrometry
Time frame: Periprocedural
the time to reach the lowest rSO2
the interval of the basal and minimal rSO2 is measured
Time frame: Periprocedural
the time to reach the highest values
the interval of the minimal to maximal rSO2 is measured
Time frame: Periprocedural
the occlusion slope
The occlusion slope was calculated based on time to reach to the lowest rSO2 as \[(baseline rSO2 -minimum rSO2)/ time to lowest rSO2\], %/minute.
Time frame: Periprocedural
Recovery slope
Recovery slope was calculated based on the time to reach the highest rSO2 value as \[(minimum rSO2 - maximum rSO2)/ time to reach the highest rSO2\], %/second.
Time frame: Periprocedural
The 10th second recovery slope
The 10th second recovery slope was calculated as \[(minimum rSO2 - at first 10th second rSO2)/ 10 second\].
Time frame: Periprocedural
This platform is for informational purposes only and does not constitute medical advice. Always consult a qualified healthcare professional.