This study at Hashemite University looks at how people with and without tennis elbow (AKA lateral elbow tendinopathy) feel pressure pain and how their bodies briefly "turn down" pain after a cold stimulus. Participants complete brief questionnaires (basic demographics without names, a tennis-elbow symptom form, and a physical-activity form) and then have their pressure-pain threshold (PPT) tested with a handheld device that slowly increases pressure on standard spots near the elbow and wrist; they say when it first becomes painful. To test the body's built-in anti-pain system (conditioned pain modulation, CPM), one hand is placed in ice water (the cold-pressor task) and PPT is measured again at set times (before, during, and after the cold stimulus) to see how much pain sensitivity changes and how long that change lasts. Both PPT reliability and CPM after effect are measured in this study. The study findings may help improve future assessment and treatment of musculoskeletal pain conditions.
This is a quasi-experimental reliability and time-course study using digital algometry for PPT and the cold-pressor task for CPM. Primary outcomes include PPT reliability (with intraclass correlation coefficient (ICC), standard error of measurement (SEM), and smallest detectable change (SDC) and the duration of CPM after-effects (time to return toward baseline). Testing is planned in the Physiotherapy Clinic at the Community Rehabilitation Center, with a minimum sample noted in the application. The protocol emphasizes standardized sites, repeated measures at predefined time points, and storage of coded data on university systems.
Study Type
INTERVENTIONAL
Allocation
NA
Purpose
OTHER
Masking
NONE
Enrollment
38
Protocols PPT Reliability The assessor measured Pressure Pain Threshold; PPT, using an electronic digital algometer. Measurements will be taken at two test sites wrist at baseline, at 1, 3 and 5 minutes. Three PPT measurements were taken at each time point with a 15-20 seconds interval between each. Mean values will then be used in analysis. Conditioned Pain Modulation In order to assess CPM, PPT was used as a tested stimulus on the painful arm (elbow and wrist). Baseline PPTs will assessed three times with an interval of 30 seconds between the repetitions. A Cold Pressure Task (CPT) will be used as the conditioning stimulus. Participants will be instructed to immerse their uninvolved hand in the ice water for 2 minutes. PPT will be measured at baseline pre and 1 minute during immersion to calculate CPM response, and then at various time points post immersion (minutes: 1, 5, 15, 30, 45, and 60) to determine the time point at which PPT returns to baseline.
The Hashemite University, Department of Physical Therapy; Community Rehabilitation Center Clinics
Zarqa, Zarqa Governorate, Jordan
RECRUITINGPressure Pain Threshold (PPT)
The assessor measured PPT (kPa) using an electronic digital algometer (Somedic AB, Sweden). Measurements will be taken at two test sites wrist at baseline, at 1 minute, at 3 minutes and at 5 minutes. Three PPT measurements were taken at each time point with a 15-20 seconds interval between each. Mean values will then be used in analysis. PPT: the amount of pressure (measured with a handheld algometer in kPa) at the moment pressure first becomes painful. Intra/inter-rater reliability of PPT: how consistent PPT readings are when the same/and another tester repeats the measurements (ICC, SEM)
Time frame: The PPT session would take about 30min to be completed in one day.
Conditioned Pain Modulation (CPM)
In order to assess Conditioned Pain Modulation (CPM), Pressure Pain Threshold (PPT) is used as a tested stimulus on the painful arm (elbow and wrist). Baseline PPTs is assessed three times with an interval of 30 seconds between the repetitions. A Cold Pressure Task (CPT) is used as the conditioning stimulus. Participants is instructed to immerse their uninvolved hand in the ice water for 2 minutes. PPT is measured at baseline prior to CPT, after 1 minute during immersion (CPT) to calculate CPM response, and then at various time points post immersion (1 minute, 5 minutes, 15 minutes, 30 minutes, 45 minutes, and 60 minutes) to determine the time point at which PPT returned to the baseline value. At each time point, PPT is measured three times with 15 to 20 second rest intervals in between. The mean value of the three measurements at each time point is used for statistical analysis. CPM after-effect (when the CPM effect returns to the baseline value) is calculated in minutes
Time frame: 1 and half hours in a separate day (different to the PPT session day)
This platform is for informational purposes only and does not constitute medical advice. Always consult a qualified healthcare professional.